1. In addition to scratches on industrial tablet computer screens, another phenomenon with greater impact is the generation of bubbles, which are caused by concentrated clicking on the same part for a long time.
I want to replace the film on time. If you find that the touch screen also generates bubbles due to excessive clicking after removing the screen saver, you can only replace the resistive film on the screen instead of replacing the entire screen.
2. If you want to greatly extend the service life of the touch screen of industrial displays, the editor of Axnew recommends choosing a high-quality screen protection film considering light transmittance, input fluency and material rigidity. The filming is also a technical job, in order from the edge to the center and then to the edge, no bubbles can be left.
3. The most severe damage to the touch screen is the handwriting input. Even if it is a high-quality screen saver, if handwriting input is used, the touch screen of the industrial tablet computer will be scratched by nails in about a month. Therefore, Axnew recommends using the pinyin input method, which is faster than handwriting input after getting used to it.
Analysis of the causes of the decline in click accuracy of Industrial Touch Screens and Countermeasures
An industrial touch monitor, which click accuracy is reduced, and the cursor is difficult to locate.
According to the experience of Axnew intelligent engineers, the analysis of the reasons for the decline in click accuracy of industrial touch screens and the countermeasures are as follows:
- Run the touchscreen calibration program. (Start-Settings-Control Panel-Sonic Screen-Calibrate button).
- If it is a newly purchased touch screen, please try to delete the driver, and then power off the host for 5 seconds to reinstall the driver.
- If the above method does not work, it may be that the reflection stripes of the Sonic screen are slightly damaged during transportation and cannot be completely repaired. You can deviate the calibration bulls eye in the opposite direction (relative to the direction deviated from the mouse) equidistantly for positioning.
- If the sonic screen is inaccurate after a period of use, it may be the reflection stripes around the screen or the surface of the transducer is covered by dust. If you are using a KA type cabinet; you can open the upper cover and use a dry soft cloth Dip industrial alcohol or glass cleaning fluid to clean the surface, and then re-run the system, pay attention to the upper left, upper right, lower right transducer can not be damaged, then power off, restart the computer and recalibrate.
- There are water droplets or other soft things sticking to the surface of the touch screen, and the touch screen misjudges that the surface acoustic wave screen is inaccurate due to hand touch, just remove it.
If you have questions about opening the touch screen, please contact us for more support.